A second generation calculator: The BULL GAMMA 10
BULL Gamma 10 electronic data processing system
In 1963 BULL (General Electric) presented the BULL GAMMA 10 (G10)
which was intended for commercial purpose and puchcard
computing. It was the direct successor of the Tabulating Machine.
Compared to the really big mainframes, the G10 was intended to
be set up in a 20 square meter room, without air conditioning.
The maximum power input was 2.5 kW.
The standard equipment contains a CPU with
panel, a punchcard reader/puncher unit and a barrel printer.
The RAM consists of a 1kb core memory which could be
extended up to 4kb capacity. There are 59 different
opcodes to program the CPU.
The cycle time from the core memory is 7 micro
seconds. The calculator is capable of reading and
punching 300 cards per minute. Five punchcards per
second, that is an amazing speed –
therefore the punching unit is generously built. The
printer can only print up to 300 lines per minute. Compared
to our Univac 9400 this
is quite slow – the Univac 9400 is capable of
printing more than 1000 lines per minute.
Gamma 10 uncovered
The chassis is metallic bright and glossy. It is clearly arranged
and therefore the machine is quite easy to maintain.
We want to repair this computer, too (see our page
We are looking for...). By now the
complete mechanics works again. After tuning the temperature
of the heated core memory and switching some defect
transistors, we can already execte a program for duplicating
punch cards, as well as the first mathematical programs.
That's really sensational for such an old computer.
The control panel could be used for monitoring running
programs, as well as for early "test driven development"
for programmers.
The picture shows details of the programmer's part of
the control panel. These buttons and switches are intended
for debugging a program step-by-step and for reading out
the contents of registers, the ALU and RAM, and, finally,
for assembling and executing new computer instructions.
All output is driven by lime-green "DM 160" miniature
tubes.
This is a picture of a typical GAMMA 10 board. On the mainboard,
all conductor paths are aligned horizontally while on the small
plug-in boards (flip-flops, amplifiers, etc.) they are mostly
vertically oriented. Almost all transistors are made of germanium.
The slow non-time-critical logic (like card controlling)
is performed by 573 relais. Building up such an amount of
wear parts is quiete brave.
Summing up, there were about 570 boards like this one in
the GAMMA 10 (without counting the printer interface). The
GAMMA 10 was sold as a quite cheap electronic data processing
system. We have got a original list of prices for this device
from 1968/69, when this model was already out-of-date and
hence very cheap:
CPU with 4kB core memory: 267.000,- DM (about 133.000,- Euro or Dollar)
Printer: 105.000,- DM (about 50.000,- Euro, Dollar)
While our GAMMA 10 is in a very good shape, we cannot use the printer any more, since all the electronics is missing. Therefore we have set up an ANALEX printer (series 5) from 1965. At that time, this printer was the fastes printer on earth, printing 1250 lines per minute. Of course he may slow down a bit for our GAMMA 10. Connecting this device to the BULL computer is supposed to be a quite complex problem. We will report about the progress on the page Development Projects, soon.
ANELEX high speed printer, series 5, with lifted cover.